Miscellaneous Tools
Founder's Circle$35.95
This ingenious little tool will allow you to close miters with inexpensive clamps and give you the joint you intended and the satisfaction of KNOWING your work is solid.This package consists of eight anodized aluminum clamping pads. When correctly... read more
Founder's Circle$9.85
Our Miter Stitch® is an ingenious little tool that allows you to close miters with inexpensive clamps and give you the joint you intended along with the satisfaction of KNOWING your work is solid.Each Miter Stitch® Set consists of two anodized... read more
Founder's Circle$116.10
The TT-1 Turning Tree works in conjunction with your outside calipers. In the past, you would set your calipers to the diameter you wish to turn by laying them on a ruler and adjust accordingly. This method is full of problems and can cause... read more
Founder's Circle$0.00
Located on the top of the DG-2 body is a solid brass assembly which is designed to allow you to set "perfect zero." You simply place the DG-2 on a clean, flat surface, loosen the locking knob, and the depth stem will plunge under its own weight... read more
Founder's Circle$0.00
A pantograph is a parallelogram device used for copying, enlarging or shrinking 2D images. There are 3D pantographs used for creating multiple copies of sculptures and other forms to avoid the tedium of producing work in quantity. Today’s copier... read more
Founder's Circle$0.00
The PB-1 Palm Brace is hard to beat for all holes up to 1/4" diameter. This capacity and range addresses most pilot hole requirements needed for screws. With amazing speed and accuracy, this brace allows you to cleanly bore holes with very little... read more
Founder's Circle$0.00
Our measuring stick system consists of six interchangeable extruded aluminum bars. The proprietary, cross-sectional profile provides unprecedented adjustment ease with absolutely rigid joints. The MS-96 "points" are uniquely designed to keep the... read more
The JM-1 JointMaker allows you to generate predictable saw or light chisel cuts with any high quality handsaw or chisel. Layout your joints (or cuts) traditionally with a marking knife, awl or a pencil. Insert the appropriate guide block in the JM-1... read more
Founder's Circle$44.10
These guide blocks, for use with your JM-1 JointMaker, are precision cut from hard rock maple and should last years with minimal care. The JM-1 JointMaker will also accept custom guides from your shop if our standard set doesn't completely meet your... read more